How-to
How to Tell If Sunglasses Fit Your Face
GlareBear November 10, 2026 3 min read
The short answer
Sunglasses fit when the frame is about as wide as your face, the bridge sits flat on your nose without pinching, and the temples reach your ears without pressing. Your eyes should sit near the middle of each lens. If the frame lifts when you smile or slides when you look down, the size or bridge is wrong for you.
The five checks
Put the pair on, look straight into a mirror and run through these in order. Each one takes a few seconds.
| Check | Good fit | Poor fit |
|---|---|---|
| Width | The frame front is about as wide as your face at the temples | The temples bow outwards, or there is a clear gap at the sides |
| Bridge | Rests evenly on your nose with no gap and no pinch | Leaves red marks, or sits on your cheeks instead of your nose |
| Temples | Run straight back and curve gently behind the ear | Press into the side of your head, or end before the ear |
| Cheeks | The frame stays put when you smile | The frame lifts off your nose when you smile |
| Eye position | Each eye sits near the middle of its lens | Your eyes sit close to the inner or outer edge |
The shake test
Look down at the floor and shake your head gently from side to side. A pair that fits stays where it is. If it slides, the bridge is too wide for your nose or the temples are too long. Our guide to reading sunglasses sizes explains the three numbers that control this.
What the size numbers tell you before you buy
If you own a pair that fits well, read the three numbers inside its temple. They are lens width, bridge width and temple length, in millimetres. A new pair within about 2 mm of those numbers on lens width and bridge width will usually sit in a similar way, as long as the shape is close. Shape still matters: a deep square frame and a shallow oval one with the same numbers will not feel the same.
- If frames often feel tight at the sides, look for a larger lens width.
- If frames slide down, look for a narrower bridge.
- If the arms press behind your ears, look for a longer temple.
What can be adjusted
Small fit problems are often fixable. An optician can usually bend metal temples, reshape acetate temple tips with gentle heat, and move adjustable nose pads. They cannot change the lens width or the bridge on a moulded frame. Adjustment is best left to someone with the right tools, because frames can crack if bent cold.
Where to start
Narrow the choice by who the frame was cut for, then compare sizes on each page under Fit: women's sunglasses, men's sunglasses or unisex sunglasses. For face shape, see which shape suits your face.
More guides
- Acetate vs Metal Sunglasses Frames: How to ChooseAcetate frames are thicker and hold rich colour. Metal frames are thinner and usually have adjustable nose pads. How to pick between them.Read the guide
- Shield and Wraparound Sunglasses, ExplainedShield sunglasses use one lens across both eyes. Wraparounds curve around the face. How they differ, how sizes work and who each one suits.Read the guide
- Sunglasses for Wide Faces: Sizes That WorkSunglasses for wide faces and larger heads: the lens widths and arm lengths that fit without pinching, and the shapes that look in proportion.Read the guide